Dust Collector Solenoid Valve

Special solenoid valves that act as pulses and are used in bag filters - bag filters - jet pulses are introduced here. This type of dust collectors to absorb and collect airborne dust particles up to about one micron and use These particles are absorbed by a suitable and strong suction device of Bag Filters system and then collected by bag filters.
This type of system is used effectively in various industries such as cement, gypsum, lime, wood, asphalt, steel, sugar, and textiles, and in general in industries that are somehow exposed to dust particles. This system consists of the following components

Dust-proof solenoid
valves provide relatively high pressure pulses to clean the filter with compressed air. For this purpose, these valves are designed so that they can pass a large flow despite the rapid opening and closing, and the time and amount of flow consumed. Reduce the air as well.

Dust control solenoid control system
usually an electronic or pneumatic control unit is responsible for opening and closing the valves quickly and sequentially, which is also known as sequencer in some brands, and accurately scheduling and closing the solenoid valves. Are in charge.

Pressure difference
regulator These directional regulators start cleaning the filters due to the pressure difference between the two clean and dusty ends of the filter. When the pressure difference

Pressure difference regulator

This regulator gives the necessary information to start the cleaning time by comparing the pressure difference between dusty and clean air on both sides of the filter. When the filter pressure pressure reaches the set value, the regulator stimulates the dust valves through the system controller. Gets stuck. After reaching a low pressure, the cleaning process stops. Through such control, the life of filters and dust valves is increased and in fact, a significant amount of air and energy consumption is saved.